Victory Reach-In Wartungshandbuch PDF herunterladen (Seite 90)

Section 8Component Replacement Procedures

8-10

Glass Door

To reverse the door swing, you will need the

proper top and bottom hinge bracket

assemblies. Order the appropriate hinge

assembly kit below to reverse the door swing:

Desired Swing Kit Number

Right-hand swing K00328

Left-hand swing K00329

1. Release the door tension by turning the

door tension adjustment screw clockwise.

2. Remove the door. See Door Removal on

page 8-11.

3. Use a 1/2” wrench to remove the top

hinge pin from the bracket assembly.

Remove the top hinge bracket.

NOTE: The top hinge bracket assembly is not

reused. However, save the mounting screws

for use with the new hinge brackets.

4. Remove the torquemaster from the bottom

hinge assembly. Perform the Door Sag

Adjustment, page 8-11, to allow you to

access the mounting screw.

5. Remove the bottom hinge bracket.

NOTE: The bottom hinge bracket assembly is

not reused. However, save the mounting

screws for use with the new hinge brackets.

6. Remove the hole plugs from the new

mounting holes. Install new hole plugs

into the old mounting holes.

7. Install new top and bottom hinge brackets.

Refer to Steps 3, 4 and 5 if necessary.

8. Remove and reconfigure the top plastic

hinge sleeve, torque rod, and hold-open

arm stud on door as shown.

Figure 8-13: Reversing Door Swing

9. Mount the door switch bumper as shown.

10. Install the door. See Door Installation on

page 8-12.

SV1227

9.50” (24.13 CM)

TO MIDDLE OF

SWITCH BUMPER

HOLD OPEN

ARM STUD

HOLD OPEN

ARM STUD

TORQUE

ARM

TOP PLASTIC

HINGE SLEEVE

RIGHT HAND SWING

LEFT HAND SWING

1 2 ... 85 86 87 88 89 90 91 92

Kommentare zu diesen Handbüchern

Keine Kommentare